Table of Contents
Advertisement
R-25
Owner's Manual
25802 Pacific Highway South
Kent, Washington 98032
All rights reserved. Reproduction or translation by any means in whole or in part is not permitted without written authorization from Ranger
Tugs. The information contained herein is correct to the best of Ranger Tugs knowledge and the contents may change without notice and
without incurring obligation.
Advertisement
Table of Contents
Related Manuals for Rangertugs R-25
Summary of Contents for Rangertugs R-25
- Page 1 R-25 Owner’s Manual 25802 Pacific Highway South Kent, Washington 98032 All rights reserved. Reproduction or translation by any means in whole or in part is not permitted without written authorization from Ranger Tugs. The information contained herein is correct to the best of Ranger Tugs knowledge and the contents may change without notice and...
-
Page 2: Table Of Contents
TABLE OF CONTENTS TABLE OF CONTENTS ..............................2 ABOUT THIS MANUAL………………………………………………………………………………………………………………………………………………3 SYMBOL GLOSSARY ..............................4 SPECIFICATIONS (SUBJECT TO CHANGE WITHOUT NOTICE) ..................5 EQUIPMENT LOCATION ............................6 STARBOARD FITTINGS ............................7 PORT FITTINGS ..............................8 MAIN CABIN TOP DECK COMPONENTS ......................... 9 STERN COMPONENTS............................ -
Page 3: About This Manual
CONGRATULATIONS The Ranger Tug family has a passion for boating. We are committed to continuous process improvement in all areas that affect our customer’s satisfaction with our products and providing great customer service. SAFETY Safety is always a concern at Ranger Tugs. Please read all manuals to insure that equipment is used in a safe manner. -
Page 4: Symbol Glossary
SYMBOL GLOSSARY Attention! – Important Operating or Maintenance Instructions Attention! – Electrical Shock Hazard Fresh Water Black Water Fuel Standard Equipment Optional Equipment Hints... -
Page 5: Specifications (Subject To Change Without Notice)
SPECIFICATIONS (Subject to Change Without Notice) Boat & Anchor Roller & Swim Step 28’ 5” Length with Swim Platform on trailer 32’ Length Overall 24’ 7” (7m) (LOA) Beam 8’ 6” (2.6m) Draft 26” (.66m) Displacement 5,750 lbs (2,608kg) Fuel Capacity 75 US Gal (284L) Fresh Water Capacity... - Page 6 Optional Equipment (Subject to Change Without Notice) Dometic Environment Air Conditioning w/ Rev cycle heat 16,000 btu Bruce Style Anchor 16.5lb/200’ Line/50’ Chain Generator 2.5 KW 12v Johnson Macerator Macerator Discharge w/ Y-valve Waste pump Garmin 5212, 4kw Radar Navigation Package Dome, GPS antennae, Depth finder Cummins Diesel Inboard Engine...
-
Page 7: Equipment Location
EQUIPMENT LOCATION STARBOARD FITTINGS 1235678, Shore Power 4, Bow Thruster Keep all vents, drains and exhausts clear of any obstructions to ensure proper performance of each system. Keel Drain... -
Page 8: Port Fittings
PORT FITTINGS Anchor Locker Drain, Engine Exhaust AC, Generator, Bow Thruster, & Macerator Keep all vents, drains and exhausts clear of any obstructions to ensure proper performance of each system. -
Page 9: Main Cabin Top Deck Components
MAIN CABIN TOP DECK COMPONENTS Mast Take Down Support Rod, Horn, Navigation Lights GPS, Radar, Searchlight, Mast... -
Page 10: Stern Components
STERN COMPONENTS Waste Pump out Cap, Waste Pump out Vent, Diesel Fuel Cap, Diesel Fuel Vent, Swim Platform, Swim Platform Retracting Ladder, Aft Bilge Pump out, Swim Platform Supports, Scupper Drains, Stern Eyes, Rudder, Trim Tabs, Propeller Stern Thruster, Depth Finder Transducer Waste Pump out Cap Swim Platform Supports, 4X Waste Pump out Vent... -
Page 11: Stern Lights
STERN LIGHTS... -
Page 12: Available Storage
AVAILABLE STORAGE... -
Page 13: Fuse Location & Values
FUSE LOCATION & VALUES The DC fuse panel is located behind a hinged access panel on the starboard side in the V-berth next to the cabin light. Fuses are automotive blade type and all values shown below are in Amps. SUB PANEL WIPERS 12 VOLT DC... -
Page 14: Main Cabin And Cockpit Lights
MAIN CABIN AND COCKPIT LIGHTS On Light DC Distribution Helm or Main Helm or Transom Helm Fixture Panel Cabin Door Switch Door Switch Switch Panel V-Berth Cabin Lights Chart Lights ... -
Page 15: Battery Compartment
BATTERY COMPARTMENT House Batteries, Engine Battery Thruster Battery, Thruster Fuses, Diesel Stove Fuse BATTERIES ENGINE HOUSE THRUSTERS Diesel Stove Fuse (15A) Thruster Fuses HOUSE/ ENGINE EMERGENCY DC PARALLEL SWITCH HOUSE BREAKER (INSIDE Thruster/Windlass ENGINE COMPARTMENT) Isolation Switch... -
Page 16: House / Engine Emergency Dc Parallel Switch
HOUSE / ENGINE EMERGENCY DC PARALLEL SWITCH This switch panel is located in the mid-cabin storage/extra sleeping area just to the port side of the main cabin entrance door, on the side of the entrance step. The switch is shown in the normal operational configuration. ... -
Page 17: Dc Distribution Panel
DC DISTRIBUTION PANEL The bilge pumps operate automatically with electronic float switches when all switches and breakers are in the OFF position. However, the BILGE PUMP and BILGE PUMP2 will run continuously once their switches are placed in the on position. Monitor the outflow accordingly. Do not run when dry. DC 12 VOLT DISTRIBUTION BILGE PUMP BILGE PUMP 2... -
Page 18: Ac Distribution Panel, Dc Battery Bank Meter, Helm Heater Control
AC DISTRIBUTION PANEL, DC BATTERY BANK METER, HELM HEATER CONTROL... -
Page 19: Wallas Stove
WALLAS STOVE Wallas 85DU Stove, Dual Burner, Heater, Diesel, 2.5 gallon tank (Refer to Wallas Owners manual for proper priming and reset functions.) Stove has a separate diesel fuel tank as shown below. Remove tank from vessel for adding fuel. DO NOT OVERFILL. Allow for fuel expansion. Wallas Exhaust Stove Fuel Line... -
Page 20: Engine Fuel System
ENGINE FUEL SYSTEM Mase 2.5 KW Diesel Generator Fuel Pick Up Fuel Return Fuel Shut Off Valve Racor Fuel Filter Engine Fuel Fill Hose Fuel Vent Hose Fuel Pick Up Fuel Fuel Fill Vent There is a secondary on engine fuel filter that is not shown on this drawing. You will be able to find information about this filter in the diesel engine manual supplied with your boat. -
Page 21: Closed Engine Cooling System
CLOSED ENGINE COOLING SYSTEM Provides alternate heating system for the Fresh Water Heater and provides primary heating source for the Forced Air Cabin Heater. The system uses a Johnson 12 volt centrifugal circulation pump (Yanmar only) fed by the coolant outlet of the engine and pumps it to the water heater and then onto the cabin heater. -
Page 22: Sea Strainer System
SEA STRAINER SYSTEM Multi Port Sea Strainer for Engine, Marine Toilet Raw Water Washdown... -
Page 23: Raw Water Wash Down
RAW WATER WASH DOWN Johnson Aqua Jet 5.2 GPM... -
Page 24: Fresh Water Plumbing System
FRESH WATER PLUMBING SYSTEM... -
Page 25: Shower Sump
SHOWER SUMP 12V, 500 GPH (This should be inspected for debris on a regular basis if shower is used frequently.) -
Page 26: Bilge Pump System
BILGE PUMP SYSTEM 12V 750GPH The bilge pumps operate automatically with electronic float switches when all switches and breakers are in the OFF position. However, the BILGE PUMP and BILGE PUMP2 will run continuously once their switches are placed in the on position. Monitor the outflow accordingly. Do not run when dry. High Bilge Alarm Forward Bilge Exhaust Forward Bilge... -
Page 27: Waste System
WASTE SYSTEM 30 Gallon Tank with Pump Out and Vent Waste tank fill level can be checked by lifting the engine access hatch and viewing the translucent waste tank. Waste tank pump out stations are widely available. Please follow the directions carefully for the pump out equipment you are using to avoid damage to the waste system. -
Page 28: Waste System With Macerator Pump
WASTE SYSTEM WITH MACERATOR PUMP 30 Gallon Tank with Macerator Pump Out, Standard Pump Out, and Vent Waste tank fill level can be checked by lifting the engine access hatch and viewing the translucent waste tank. Pump out can be done with the macerator or standard pump out. The Y-Valve that switches between the two can be accessed through the hatch under the bait tank/seat on the aft cabin. -
Page 29: Mast Set Up And Takedown
MAST SET UP AND TAKEDOWN MAST SET UP PROCEDURE 1. Remove the two black plastic wing nuts from the mast base. 2. Remove the two mast tie down cables from their storage positions in the roof clips. 3. With the mast tie down cables still loose, raise the mast off of the stainless steel support bar. -
Page 30: Working Decks
WORKING DECKS... -
Page 31: Care And Maintenance
CARE AND MAINTENANCE The following checklists are examples and are not all inclusive and are provided only as a guide. Please customize to your personal needs. Consult your engine and trailer user manuals for additional information. EXAMPLE OF A PREPARATION FOR THE ROAD CHECKLIST TOW VEHICLE –... -
Page 32: Example Of A Spring Pre-Launch Checklist
EXAMPLE OF A SPRING PRE-LAUNCH CHECKLIST CLEANING: o Remove debris from scuppers and scupper drains. o Clean hull using a mild biodegradable detergent and then wax. o Clean topsides and decks using a mild biodegradable detergent and then wax. o Clean and polish all bright work. o Clean and oil teak. -
Page 33: Example Of Winter Storage Checklist
EXAMPLE OF WINTER STORAGE CHECKLIST GENERAL MAINTENANCE: o Fill Fuel Tank and add a fuel stabilizer. o Empty and clean black water tank. o Empty fresh water tank use a non-toxic antifreeze per manufacturer’s directions. o Winterize black and fresh water tanks as necessary based on weather. o Check bilge area for oil and for proper operation o Check zincs and replace as necessary. -
Page 34: Reference Material
REFERENCE MATERIAL The following table contains a list of reference materials provided by Ranger Tugs that are contained under separate manuals. EQUIPMENT ORIGINAL MANUFACTURER Navigation System Raymarine Engine Yanmar / Cummins Stove, diesel Wallas Trim Tabs Bennett Thrusters Side Power Search Light Jabsco Raw Water Wash Down... -
Page 35: Contacts
CONTACTS Customer Service – Andrew Custis Customer Service Manager Phone 253-839-5213 andrewcustis@rangertugs.com Web Site – www.rangertugs.com...