Vaterra 1967 Ford Mustang Owner's Manual page 14

/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
14
led indicator
oPeration led StatuS
Stop OFF
Forward Blinks
Forward (full speed) Solid
Reverse Blinks
Brake Blinks
Brake (full brake) Solid
Ni-MH/Ni-Cd Battery
2S Li-Po Battery
ESC Ready
Battery Low Voltage Blinks
Overheat Blinks
ProGraMMinG the eSc
The ESC comes with two jumpers pre-installed in the
REV: ON and BATT: Ni-MH configurations. To disable reverse
or change the battery type to Li-Po, disconnect the jumper
from the default port and connect it to the desired port. Power
off the ESC, then power it on again. If the jumpers are lost or
not installed, the ESC will default to REV: ON and BATT: Li-Po.
Sound at PoWer uP
1 Short Beep
2 Short Beeps
1 Long Beep