Dacor OBC36 Installation Instructions

WARNING:
1. Since the cart and the grill are heavy, this installation process should be accomplished
by a minimum of two people. Remove all individual components to lighten the grill before
installation. Remove the cart from the shipping pallet before installation.
2. Sheet metal edges can be dangerous in heavy lifting situations. Please wear gloves during
installation.
3. Attach the appliance to the cart with all of the supplied bolts before use.
4. Read the use and care manual completely before operation.
NOTES:
1. The Dacor cart ships assembled ready for installation of the outdoor grill.
2. All gas and electrical connections should be made after the grill is installed and bolted to the
cart.
3. Your cart is prepared for either natural gas or liquid propane (LP) gas connections. However, it
is important to verify that your outdoor grill was ordered correctly. If you will be utilizing LP gas,
your grill must indicate LP in the model number. Do not proceed with installation if the model is
not correct. Field conversion from one gas type to another is not permissible.
ASSEMBLY:
1. Remove the cart from the shipping carton and pallet.
2. Set the cart in an open location and lock the wheels
on the cart to minimize potential movement.
3. Remove the drawers.
4. Remove the outdoor grill from its shipping carton and
pallet. Remove the parts box to lighten the appliance.
5. As you place the outdoor grill on the cart, feed the
gas line and electrical cord into the utility cut-out on
the cart.
6. Center the unit on the cart, making sure to line up the
threaded mounting holes under the bottom of the grill
with the holes in the top of the cart.
7. Thread all of the supplied bolts into the bottom of the
outdoor grill from inside the cart. Tighten the bolts into
place.
8. Install the side shelves if desired. See next page.
9. Before installing the front drawers and tank shelf,
connect the regulator and gas supply line according
to the Outdoor Grill Installation Instructions.
WARNING:
• To avoid an explosion hazard, do not connect the cart
or appliance(s) to electrical power until after the gas
supply system has been checked for leaks.
10. Install the drawers. Put the LP tank on the tank shelf
and connect it, if applicable.
CAUTION:
• The largest recommended LP tank size for the rollout
tank shelf is five gallons.
Part No. 102044 Rev C
continued...
Installation Instructions
Outdoor Grill Cart
Covers Models OBC36, OBC52, OBCW52
Locking Wheel
Utility
Cut-Out
Tank
Shelf
Fixed Wheel