Operation; Warming Up The Engine - Sears 917.257061 Owner's Manual

FIGURE 9
IGURE 10
OPERATION
STARTING 1 HE ENGINE
1.
Pla ce Parking Br a ke Le ve r In lo c ke d PO Slt, o n (Fig . 9 1.
2.
Place Attachment Clutch Pedal in "OFF" position (Fig. 10)
3.
Pla ce Gear Shift Lever in neutral "N" POSit ion (Fig. 11) .
4.Move Range Shift Lever
to
"N" neutral positio n (Fig . 11).
5.Push Clutch · Bra ke Pedal into bra ke POSiti on IF,g
12) .
6.
Move Throttle Control Lever to middle pos it io n (F ig. 13) .
7.
Pull Choke out (F ig. 13).
S.
Turn Ignition Key to "START" position until Engine starts
(Fig . 13). Release key into "ON" position.
NOTE : DO NOT RUN STARTER CONTINUOUSLY FOR
MORE THAN THIRTY SECONDS AT A TIME. If engine
does not start after several attempts, move Throttle Control
Lever to "FAST" posit ion, wait a few minutes, and try
again.
NOTE: The Electric Lift Switch (F ig.
13)
raises or lowers
an attachment when used with a Three Point Hitch (optional
equipment).
WARMING UP THE ENGINE
Move Throttle Control Lever to slow position . Push Choke
in as engine warms. NOTE: ALLOW ENGINE TO WARM
UP FOR A FEW MINUTES BEFORE OPERATING .
When restarting a warm engine, move Throttle Control Lever
to middle position, Choke may not have to be used .
A
ALWAYS WEAR SUBSTANTIAL FOOT·
WEAR AND AVOID LOOSE FITTING
CLOTHING THAT COULD GET CAUGHT
IN MOVING PARTS .
LEARN TO START, STOP AND REVERSE
YOUR TRACTOR IN A LARGE, OPEN
SPACE .
. 4 · . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .