Propel RC Air recon User Manual
Propel RC Air recon User Manual

Propel RC Air recon User Manual

Indoor helicopter with camera
Hide thumbs Also See for Air recon:

Advertisement

BATTERY WARNINGS

RECHARGEABLE BATTERY:
This helicopter uses an internal Li-Poly rechargeable battery and is not replaceable. If battery no longer stays
charged, dispose of battery properly according to local disposal requirements.
CONTROLLER BATTERIES:
Remote control requires 6 "AA" batteries (not included). Please read the important battery safety warning below.
• Do not mix alkaline, standard (carbon-zinc) and rechargeable batteries (Nickel Metal Hydride).
• Do not mix old and new batteries.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the item before being charged (if removable).
• Rechargeable batteries are only to be charged under adult supervision.
• Exhausted batteries should be removed immediately and must be recycled or disposed of properly according to
state or local government ordinances and regulations.
• The supply terminals are not to be short-circuited.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity (see inside booklet for diagram).
• Do not dispose batteries in a fire - batteries may leak or explode.

CARE AND MAINTENANCE

• Always remove the batteries from the wireless infrared remote control when it is not being used for an extended
period of time.
• To clean, gently wipe the remote control and helicopter with a clean damp cloth.
• Keep the toy away from direct heat or sunlight.
• Do not submerge the toy into water. This can damage the unit beyond repair.
• Parental guidance recommended when installing or replacing the batteries.
FCC Part 15 B Notice
CAUTION: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Conforms to safety requirements of ASTM, CPSIA and FCC.
PROPEL RC™ and AIR RECON™ are trademarks of Rooftop Brands.
©2012 Rooftop Brands™ All rights reserved
Tel: + (1) 949-566-9573 • www.rooftopbrands.com
Made in China
11
THIS PACKAGE CONTAINS:
CHOKING HAZARD - Small parts.
Not suitable for children under 3 years.
INDOOR HELICOPTER WITH CAMERA
USER MANUAL
WARNING: AIR RECON
is an indoor infrared helicopter. Infrared signals cannot
TM
function in daylight due to interference from the sun. In addition, your AIR RECON
helicopter is not suited to handle wind or other outdoor environmental conditions.
Attempting to fly this helicopter outdoors may lead to severe damage.
L
R
Camera
Light
Helicopter
Controller
Micro SD card
Colors and styles may slightly vary.
TM
Card reader
USB charging cord
Spare parts

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Air recon and is the answer not in the manual?

Questions and answers

Summary of Contents for Propel RC Air recon

  • Page 1: Battery Warnings

    Infrared signals cannot equipment off and on, the user is encouraged to try to correct the interference by one or more of function in daylight due to interference from the sun. In addition, your AIR RECON the following measures: helicopter is not suited to handle wind or other outdoor environmental conditions.
  • Page 2: Table Of Contents

    (see diagram F). USB charging time may vary depending on the amount of charge needed to fill the helicopter battery. The average USB Thank you for purchasing the AIR RECON™ 3 Channel IR Gyro Helicopter. Please read this instruction booklet charging time is 25-30 minutes.
  • Page 3: Preparing For Flight

    OUTDOORS. Set your helicopter on a clean flat surface before take-off. Tail Rotor Blade HOW TO SYNC YOUR HELICOPTER Your AIR RECON™ utilizes an automatic multi-channel selection system that allows up to 3 people to fly side by side in the same wireless range. FOR ONE PERSON PLAY: Body Shell 1.
  • Page 4: Understanding Helicopter Trim Adjustments

    Press the TURBO button on the front of the controller (see CONTROLLER DIAGRAM pg 3 ) and your AIR RECON helicopter will change into high-speed mode. Press the TURBO button a second time to go back to the original speed. Press the LIGHT button on NOTE: To make nice sweeping moves you will need to first be moving forward at a decent pace.
  • Page 5: Replacing The Upper Propeller Blade

    Using a screwdriver turn counterclockwise Remove the broken blade and Your AIR RECON propeller system is a precision instrument that may need repair or replacement from time to time for to remove the screw. carefully replace with a new one.
  • Page 6: Using Your On Board Camera And Video Recorder

    RED. This indicates that its time put a new SD card in your helicopter or download files and clear space for future and follow instructions to format your Micro SD card. photos and videos. INSTALLING THE MICRO SD CARD IN YOUR AIR RECON HELICOPTER • Make sure helicopter is in the power “OFF” position.

Table of Contents