Table of Contents
Advertisement
Problem
Washing machine does not
work.
The door cannot be closed.
Display shows: "Selection
error".
Display shows: "Door not
Closed/Please check"
Display shows: "No inco-
ming water/Check tap &
Hose"
Washing machine vibrates
when operating or is noisy.
Washing has not been
spun.
Water is running out from
under the washing
machine.
Possible cause
Mains plug not plugged
in or fuse not working.
Door not closed properly.
START/PAUSE key was
not pressed for long
enough.
Child safety device en-
gaged.
The selected function
cannot be combined
with other programme
settings.
Door not closed properly.
Tap turned off.
The filter in the threaded
inlet hose fitting is
blocked.
Water tap is blocked
with limescale or faulty.
Transit packaging has
not been removed.
Screw feet not correctly
adjusted.
Only a few large items of
washing in the drum.
Screw connection on the
inlet hose is leaking.
Drain hose is leaking.
Drain pump cover is not
closed properly.
Washing was caught in
the door.
Emergency drain hose is
leaking.
Remedy
Plug in mains plug. Check
fuse.
Close door - there should be
an audible click.
Press START/PAUSE key for
longer.
Release the child safety de-
vice.
Make another selection.
Close door - there should be
an audible click.
Start programme again.
Turn the tap on.
Turn off the tap. Unscrew the
hose, take out the filter and
clean it.
Check the water tap and have
it repaired if necessary.
Remove transit packaging.
Adjust feet according to the
Installation and Connection
instructions.
Always load the drum as full
as possible. Mix large and
small items.
Screw the inlet hose in firmly.
Replace drain hose.
Close the cover properly.
Load washing carefully for
the next wash.
Close off emergency drain
hose properly.
27
Advertisement
Table of Contents
