Table of Contents
Advertisement
HR80UK Radiator Controller
In the standard CM Zone Pack the HR80UK Radiator Controllers are pre-bound to each zone as indicated by the zone number label.
To add additional HR80UK Radiator Controllers to a zone refer to Section 8: Changing the Configuration.
1
a
1
Note: Zone number label
Turn the locking knob
and separate
a
the operating module from the coupling
module.
4
Install batteries into the operating
module.
Note: Check correct polarity.
a
A selection of adaptors are available to suit many other TRV manufacturers. For more information please contact Honeywell
Technical Help Desk, details on the back page.
The HR80UK Radiator Controller provides local room temperature control based upon
setpoint information received from the CM67z Room Unit and sends Load Demand
signals based upon room conditions to the HC60NG Relay Module. Setpoints can be
temporarily overridden using the adjustment dial.
The HR80UK can be fitted onto Honeywell VT5, VT7, VT200 and many other manu-
facturers TRV bodies with a M30x.5mm thread and a 2.9 - 0.5 mm valve closing point,
adaptors may be available for manufacturers with non standard connections. For more
information contact Honeywell Technical Help Desk, details on the back page.
When selecting the operating site of the HR80UK ensure that the dis-
!
tance to other wireless devices such as wireless headphones, cordless
phones etc. is at least 1-2m.
Caution!
2
c
Turn the coupling module wheel
clockwise (approx. 3 rotations) until the
nose
reaches the end stop
b
5
a
1
Fit the operating module onto the cou-
pling module and turn the locking knob
down to lock in place.
a
b
c
Section 6: HR80UK Radiator Controller
3
b
a
anti-
Fit the coupling module
a
body
.
c
For Adaptors see below.
6
When adaption is complete the room
temperature set-point is displayed.
d
e
5
a
to the TRV
a
and tighten by hand.
b
f
g
b
Advertisement
Table of Contents
