Advertisement
13. Release video screen from locked position.
Lower video screen to viewing position for
access to mounting location in top of video
system housing.
14. Raise video system into approximate position
and connect all wiring to components. Connect
wiring and cabling to video system per
instruction included with video system.
15. Check function of all component and lights. See
operating instruction for video system operations check.
For further assistance, refer to the video
system manual for the technical support phone
number listed for your area.
16. Insert video system into opening in console.
Note : Make sure wires do not get pinched between video system and console.
Align holes in housing with clips in mounting bracket. Secure using (4) four 6-32x 3/4" screws
(item 2 pg.2) and (4) four 3.5mm washers (item 3 pg. 2). See Figure 8.
Caution : Do not overtighten screws.
FIGURE 9
17. Tighten screw previously installed to secure rear of
console to headliner.
Caution: Do not overtighten screws or damage to
vehicle roof may occur.
18. Raise video screen into locked position.
19. Install speaker grille (item 9 pg 2). Align clips in grille
with holes in console and press firmly. See Figure 9.
20. If speaker upgrade kit was not installed, install cover
plate (item 10 pg 2) at front of console and secure using
(2) # 6 X 1/2" screws (item 5 pg 2).
21. Install cover plate decal (item 11 pg 2).
6
FIGURE 8
Advertisement
