Makita HM0810B Instruction Manual page 8

Lubrication
Lubricate the tool every time the carbon brushes are replaced.
Run the tool for several minufes to warm
it
up, then rest the tool on the table with
the bit end pointing upwards.
This will allow the old grease to collect in-
side the crank housing. After five minutes,
take off the crank cap and remove the old
grease. Wipe out all grease inside and re-
place with a fresh supply (30 g; 1 oz.)
CAUTION :
0
Filling with more than the specified
amount of grease (approx. 309; 1 oz.)
can cause faulty hammering action or
tool failure. Fill only with the specified
amount of grease.
0
Use only Makita genuine grease. The use
of any other grease may harm the tool.
Lock
nut
wrench
/
\
I
,
0
Do not tighten the crank cap excessively when installing. It is made of resin and i s sub-
ject to breakage.
To maintain product SAFETY and RELIABILITY, reparis, any other maintenance or
adjustment should be performed by Makita Authorized
or
Factory Service Centers,
always using Makita replacement parts.
8