IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
JBL customers, allowing JBL engineers to design products that meet their needs and expectations. The JBL On Air WEM-1 is an advanced wireless system that allows you to enjoy your favorite music in remote locations around your home, using almost any loudspeaker.
Page 4
A/V receiver, audio component, computer or portable music player. The JBL On Air WEM-1 may be connected to your source in several ways. First, determine how you would like to use the WEM-1; then follow the setup instructions for that application.
RF lock (i.e., the LED on the receiver is solid green). Using the remote control the WEM-1 until its output level is balanced with the rest of the speakers in your surround system. From this point on, you will not be using the WEM-1 remote control for volume settings.
The JBL On Air WEM-1 will automatically enter the Standby mode after approximately 10 minutes, when no signal is detected from your system. The WEM-1 will then power on instantly when a signal is detected. When Mute is engaged, auto turn-off is deactivated.
Vertically Stand-Mounting the Receiver Module Step 1. Remove the corner screws located on the left side of the receiver module when viewed from the bottom, looking at the front, as shown in Figure 8. Figure 8. Step 2. Rest the receiver module on top of the stand and reattach the two screws that were removed in Step 1 through the holes in the stand into the bottom of the receiver module, as shown in Figure 9.