JBL ON AIR ™ WEM-1 Transmitter/Receiver/Amplifier SERVICE MANUAL JBL Consumer Products 250 Crossways Park Dr. Woodbury, New York 11797 Rev1 11/2008...
Page 2
On Air WEM-1 Service Note: WEM-1 systems should be exchanged under the warranty period; the electronics are not serviceable down to component level. Order the following parts when needed: Mechanical parts see page 7 Transmitter part# 015-7600-00031-E Receiver/Amplifier part# 010-7604-05194-E - CONTENTS - BASIC SPECIFICATIONS…………………….……………………..1...
Page 4
A/V receiver, audio component, computer or portable music player. The JBL On Air WEM-1 may be connected to your source in several ways. First, determine how you would like to use the WEM-1; then follow the setup instructions for that application.
Page 6
Using the remote control 1 and 2, adjust the volume level of the WEM-1 until its output level is balanced with the rest of the speakers in your surround system. From this point on, you will not be using the WEM-1 remote control for volume settings.
Page 7
The JBL On Air WEM-1 will automatically enter the Standby mode after approximately 10 minutes, when no signal is detected from your system. The WEM-1 will then power on instantly when a signal is detected. When Mute is engaged, auto turn-off is deactivated.