JBL MPC Owner's Manual
  1. Manuals
  2. Brands
  3. JBL Manuals
  4. Amplifier
  5. MPC
  6. Owner's manual

JBL MPC Owner's Manual

Jbl owner's manual power amplifiers mpc
Hide thumbs

Advertisement

Table of Contents

MPC Series
Power Amplifiers
Owner's Manual
TD-000074-00
TD-000074-00
Rev. C

Advertisement

Table of Contents
loading

Related Manuals for JBL MPC

Summary of Contents for JBL MPC

  • Page 1 MPC Series Power Amplifiers Owner’s Manual TD-000074-00 TD-000074-00 Rev. C...
  • Page 2 Table of Contents...

  • Page 3: Warning Notices

    Cautions Sicherheitsvorschriften CAUTION VORSICHT TO AVOID ELECTRIC SHOCK, DO NOT INSERT FINGERS UM ELEKTRISCHEN SCHLAG ZU VERMEIDEN, KEINE OR OBJECTS INTO ANY OPENINGS IN THE CHASSIS. FINGERN ODER GEGENSTÄNDE IN ÖFFNUNGEN DES GEHÄUSES STECKEN. Warning notices...
  • Page 4 Description × × × × × × × × × × × × s t l s t l × × × × × × s t l × × ×...
  • Page 5 MPC600T front panel (MPC300, 300T, and 600 are similar) MPC200T front panel (MPC200 is similar) 1 Power Switch 2 Power Indicators (Ch. 1 & Ch. 2) 3 Signal Indicators (Ch. 1 & Ch. 2) 4 Clip Indicators (Ch. 1 & Ch. 2) 5 Protect Indicators (Ch.
  • Page 6 Inputs Loosen screw, insert wire here, then tighten screw. Wire jumper between input and ground Shield Signal conductor...
  • Page 7 LOW IMPEDANCE AUDIO TRANSFORMER 70 100 TO 140V LINE DIR. OUTPUT ISOL.OUTPUT BRIDGE 100V MONO Output connection for MPC, parallel or stereo mode. OUTPUT OUTPUT BRIDGE BRIDGE MONO MONO Output connection for MPC “T” models, direct low impedance. LOW IMPEDANCE...
  • Page 8 Driving Distributed Lines...
  • Page 9 Although driving too low an impedance will not harm your MPC amplifier, it might activate its protection circuitry or cause less-than- optimal performance. When in doubt about actual loudspeaker characteristics, we recommend you use a slightly higher nominal load impedance on the LOW IMPEDANCE output and/or a slightly lower total power demand (i.e., sum of all the power taps) on the AUDIO TRANSFORMER outputs than what the following...

  • Page 11: Bridged Mono Mode

    élevée que 160 volts rms between the MPC sont disponible aux bornes amplifier’s bridged termi- du amplificateur MPC en nals (200 volts at isolated mode bridgé mono (200 outputs). volts aux sorties isolés). MPC200T, MPC300T, and...
  • Page 12 When operating the amplifier in bridged mono mode, neither of the speaker wires is at ground potential. Grounding either of the speaker wires can short out one side of the power amplifier. Use the same precautions in handling and dressing the wire as you would for the normal “hot” outputs. Ensure that neither wire connects to ground anywhere along its length.

  • Page 13: Parallel Mono Configuration

    Parallel Mono Configuration...
  • Page 14 Controls Displays Models MPC300, MPC300T, MPC600, & MPC600T Models MPC200 & MPC200T...

  • Page 15: Operation

    AC Power Operation Protection Circuits...
  • Page 16 Glossary...

  • Page 17: Specifications

    Specifications...

  • Page 18: Power Consumption

    Power Consumption l l u...

  • Page 19: Heat Emission

    Heat Emission l l u / l a / l a / l a / l a...

  • Page 20: Troubleshooting

    Troubleshooting...

  • Page 21: For Further Assistance

    For Further Assistance...
  • Page 22 JBL Professional 8500 Balboa Boulevard, P.O. Box 2200 Northridge, California 91329 U.S.A. A Harman International Company MPC MANUAL 6/98...

This manual is also suitable for:

Mpc seriesMpc200Mpc200tMpc300Mpc300tMpc600 ... Show all

Table of Contents