Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for PSI Audio Loudspeaker
Summary of Contents for PSI Audio Loudspeaker
- Page 1 PSI Audio User Manual UANPA10 V2.7 PSI Audio User Manual...
-
Page 2: Table Of Contents
ULTI CHANEL PERATION TROUBLESHOOTING ............................. 12 ........................12 OWER ON DOES NOT LIT ....................... 12 NBALANCED TO BALANCED OPERATION ............................ 12 OOR AUDIO QUALITY ........................12 NEVEN FREQUENCY RESPONSE C.E.CONFORMITY............................12 WARRANTY ..............................12 UANPA10 V2.7 PSI Audio User Manual... -
Page 3: Introduction
• Please do not open the loudspeaker - risk of electric shock inside. • Make sure not to expose the loudspeaker to any form of liquids. For cleaning purposes use only a dry cloth. In order to prevent spills, do not place any containers containing liquid on the loudspeaker. -
Page 4: Service
(see point 3.3.). 3 General Overview Before you start Special care have been taken in the packaging of your PSI Audio equipment. Before you start to install it, please check that the following parts are included : • Loudspeaker •... -
Page 5: Front Panel Description
Level / Input Sensitivity Potentiometer NE PAS OUVRIR Audio input signal calibration C AU TION GEFAHR : ELEKTRISCHER SCHLAG NICHT ÖFFNEN POWER Power On / Off Switch Voltage Selector / Mains Fuse Selects AC voltage and fuse value UANPA10 V2.7 PSI Audio User Manual... -
Page 6: Quick Start
Setting it up naturally takes a certain amount of time. However, in case you need to get started quickly, please follow the quick set up guide. The rest of this manual will assist you in setting up your loudspeaker system and calibrate it according to your listening environment. -
Page 7: Audio Signal Input Connector
When using the loudspeaker in the studio environment, the Roll-Off control allows the low frequency response to be tailored according to the position of the loudspeaker. Placing a speaker in a corner or near a wall will affect the bass response and this can be compensated by use of the calibration control. - Page 8 - 7 dB Fig 1 – Full space : Roll off @ cal. Point Fig 2 – Half-space : Roll off @ ~ - 4dB Fig 3 – Quart-space : Roll off @ ~ - 7dB UANPA10 V2.7 PSI Audio User Manual...
-
Page 9: Mounting
The high frequency section should be at ear height or slightly higher. This is valid for any music listening mode (stereo, multichanel, etc..). - Page 10 Stereo & sub system calibration • The sub level being now calibrated, the signal from the first monitor should go through the sub and its Roll-Off adjusted @ -10dB Stereo & sub system in practice UANPA10 V2.7 PSI Audio User Manual...
-
Page 11: Multi Chanel 5+1 Operation
Surround Speaker : 72 dBC each Subwoofer : for film mixing, the subwoofer level has an extra 10dB of headroom. This means that the subwoofer level should be calibrated accordingly i.e. 85 dB in band. UANPA10 V2.7 PSI Audio User Manual... -
Page 12: Troubleshooting
Please check that the power switch is set on the ON position and that the mains cable is properly connected to the mains. If the problem persists, check the fuse, the voltage selector and the AC power voltage. If this still not solve the problem, contact PSI Audio or a PSI Audio authorised dealer. Unbalanced to balanced operation It can give rise to problems and special care should be taken in wiring.
Need help?
Do you have a question about the Loudspeaker and is the answer not in the manual?
Questions and answers