Timeouts; Laser Timeout - IBM 4685-L0D Setup, Operation, And Service Manual

Speaker tone = low
Use this bar code to set the speaker
tone to low.
Speaker tone = medium
Use this bar code to set the speaker
tone to medium.
Speaker tone = high
Use this bar code to set the speaker
tone to high.
Power-up tone–enable
Use this bar code to enable the tone
sounded on power-up.
Power-up tone–disable
Use this bar code to disable the tone
sounded on power-up.

Timeouts

By using timeouts, you can have the scanner's laser and/or motor switch off if the
scanner isn't used for a specified period of time. This feature is included to reduce
power consumption and lengthen scanner life.
Note: Laser safety requires that the laser switch off before the motor. If you set
the motor timeout shorter than the laser timeout, the laser will switch off when the
motor times out.

Laser timeout

The programming bar codes for laser timeout set the time for switching the laser off
if the scanner isn't used.
Laser timeout = 5 minutes
Use this bar code to set the laser
timeout to 5 minutes.
3-7
Chapter 3. Configuration of the 4685-L0D Scanner