Table of Contents
Advertisement
c. Move charger and battery pack to a location where the surrounding air
temperature is approximately 18°- 24°C (65°F - 75°F).
d. If charging problems persist, take the tool, battery pack and charger to your
local service center.
4. The battery pack should be recharged when it fails to produce sufficient power on
jobs which were easily done previously. DO NOT CONTINUE to use under these
conditions. Follow the charging procedure. You may also charge a partially used
pack whenever you desire with no adverse affect on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited to, steel wool,
aluminum foil, or any buildup of metallic particles should be kept away from
charger cavities. Always unplug the charger from the power supply when there
is no battery pack in the cavity. Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
WARNING: Shock hazard. Do not allow any liquid to get inside charger.
CAUTION: Never attempt to open the battery pack for any reason. If the plastic
housing of the battery pack breaks or cracks, return to a service center for recycling.
INSTALLING AND REMOVING THE BATTERY PACK (FIG. 1)
NOTE: Make sure your battery pack is fully charged.
WARNING: To reduce the risk of serious personal injury, make certain the lock-
off button (B), as shown under Components, is engaged to prevent switch
actuation before removing or installing battery.
FIG. 1
To install the battery pack into the tool handle, align the base of the tool with the
rails inside the tool's handle and slide the battery pack firmly into the handle until you
hear the lock snap into place.
To remove the battery pack from the tool, press the release button (J) and firmly pull
the battery pack out of the tool handle. Insert it into the charger as described in the
charger section of this manual.
COMPONENTS (FIG. 2, 3)
A. Trigger switch
B. Lock-Off Button
C. Spindle lock button
D. Side handle
E. Abrasive wheel
FIG. 2
C
E
J
7
F. Anti-lockup backing flange
G. Threaded clamp nut
H. Guard (Type 1, Type 27)
I. Battery pack
J. Battery release button
B
A
D
H
I
J
Advertisement
Table of Contents
