Desa Vanguard VMH26TPC Owner's Operation And Installation Manual page 11

Vanguard vent-free compact fireplace
Hide thumbs Also See for Vanguard VMH26TPC:
Table of Contents

Advertisement

INSTALLATION
Continued
WARNING: If pre-wiring, do
not connect wiring to any electri-
cal source at this time.
Install fireplace electrical outlet
and connect wiring to outlet
before connecting to electrical
source. The fireplace electri-
cal outlet is included with the
GA3450T blower accessory.
Only use the fireplace electri-
cal outlet supplied with the
GA3450TA blower accessory.
2. If installing GA3450TA blower accessory, do
so at this time. See Installing Blower Acces-
sory GA3450TA, page 13.
Note: If not installing blower accessory, you
may wish to run electrical wiring to your
fireplace for future blower installation (see
Accessories, page 30) Use only approved
three-wire electrical wiring.
Note: A qualified installer should make all
electrical connections.
3. Install gas piping to fireplace location. This
installation includes an approved flexible gas
line (if allowed by local codes) after the equip-
ment shutoff valve. The flexible gas line must
be the last item installed on the gas piping.
4. If you have not assembled firebox, follow
instructions on page 4.
5. Carefully set fireplace in front of rough opening
with back of fireplace inside wall opening.
6. Attach flexible gas line to fireplace gas regula-
tor. See Connecting to Gas Supply, page 16.
7. Bend four nailing flanges on outer casing with
pliers (see Figure 10).
8. Attach fireplace to wall studs using nails
or wood screws through holes in nailing
flange.
9. Check all gas connections for leaks. See
Checking Gas Connections, page 18.
10. If using optional trim kit, install the trim after
final finishing and/or painting of wall. See
instructions included with trim accessory for
attaching trim.
IMPORTANT: When finishing your firebox,
combustible materials
113111-01D
WARNING: Do not allow any
combustible/noncombustible
materials to overlap the firebox
front facing.
noncombustible materials to
cover any necessary openings
like louvered slots.
cover the louvered slots on the
front of the firebox.
Figure 8 - Rough Opening for Installing
Figure 9 - Rough Opening for Installing
Nails or
Wood
Screws
Figure 10 - Attaching Fireplace to Wall
www.desatech.com
WARNING: Do not allow
WARNING: Never modify or
10
1
/
26
7
"
/
8
26
7
"
/
8
in Wall
36
"
5
/
8
26
"
7
/
8
51
"
3
/
4
in Corner
Studs
"
2
3/4" Off
The Floo r
Minimum
25
7
"
/
8
Nailing
Flanges
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vanguard vmh26tnc

Table of Contents