BYD L3 AUTO Owner's Manual page 145

Do not remove the bolts, just loosen
them by rotating one cycle and a half.
TIPS
Do not apply engine oil or
lubricant on the bolts, or they will
get loose, which may cause the
wheel detached and
serious accident.
Jack Positioning
4. Place the jack under the proper
lifting point.
Make sure that the jack is placed on
flat and solid ground.
BYD L3 AUTO Owner's Manual
Lift Up Vehicle
lead to
5. Make sure nobody is in the car,
and lift up the car to a height that
allows installation of spare tire.
Please notice that it needs larger
clearance to install the spare tire than
remove the flat tire.
To lift up the car, please insert the
jack handle into the jack (loose joint)
and rotate it clockwise. When the jack
touches the car and starts lifting,
please check again if the jack is at the
right position.
TIPS
When the car is supported
completely by jack, no one is
allowed to stay under the car.
Replace Wheels
6. Remove wheel bolts and replace
the tire.
Take off the flat tire and put it aside.
Roll the spare tire to the installation
position, align the bolt to tire hole, and
then raise the tire until the top bolt fit
into the screw hole. Rotate the tire
push it until all bolts can fit into
corresponding screw holes.
Emergency Treatment 4-9