BD825 Envy as described above. Note: a) In the case where the BD825 Envy has not been used for a long time or the internal battery has run completely flat, it may take several minutes before the Red LED lights up.
Page 4
1) Pairing Procedure a) Place the BD825 Envy and the audio device or mobile phone within 3 feet of each other b) The BD825 Envy should be Power Off c) Press and hold the MFB (multi-function-button) for 6 seconds until the Red LED and Blue LED start to flash alternately……the BD825 Envy is now in Pairing mode...
Page 5
(multi-function-button) on the BD825 Envy and manual acceptance of the connection on the audio device or mobile phone. Connection a) Every time the BD825 Envy is turned on, it will automatically search and connect to the last connected Bluetooth device. Note: Some Bluetooth devices require manual acceptance of the BD825 Envy’s signal...
Page 6
During a call, when the 2nd call comes in, press and hold either “V+”or “V-” button on the BD825 Envy for 3 seconds to answer the 2nd call Call Swap a) With two callers on the BD825 Envy, press and hold either “V+”or “V-” button for 3 seconds to swap between the two callers. Note: Call holding can only be done only if your mobile phone and its SIM support this function.
Page 7
Simultaneous Pairing to Audio Video Device and Mobile Phone The BD825 Envy can be paired with an Audio Video device and a mobile phone at the same time, allowing the user to play music from AV device, and make or receive phone calls on the mobile phone using the BD825 Envy.
Page 8
Guide of your device for operation procedure. During music playback, if a call comes in on your mobile phone, the BD825 Envy will stop the music playing and the ring tone will be heard through the earphones, answer or reject incoming call as previously described.
Need help?
Do you have a question about the BD825 Envy and is the answer not in the manual?
Questions and answers