Rinse Agent - GE GSD500 Use And Care Manual

Good Dishwashing Starts with HOT Water
To get dishes clean and dry, you need hot water. For good washin
the entering water must be at least 120°F. To prevent dish damage, inlet water should not exceed 150°F.
How to Test Water Temperature
thermometer. Turn on the hot water faucet nearest
temperature stops rising. If the water temperatur
below 120°F., adjust your water heater.
How to Use a Rinse Agent
The rinse agent makes water flow off dishes
quicker than usual. This lessens water spottin
and makes drying faster, too.
For best dishwashing performance, use of a rinse
Rinse agents come in either liquid or solid form.
Your dishwasher uses the liquid form.
How to fill the rinse agent dispenser.
Unscrew the cap. Note the FULL
line on the top of the cap. Add
liquid rinse agent until it just
reaches the top of the FULL line.
Replace the cap. The dispenser
automaticall releases the rinse
y
agent into the final rinse water.
6
with a candy or meat
e
is
e
g
Full
g
Helpful hints: lf
outside temperatures are unusua]]y
or if your water travels a long distance from water
low,
heater to dishwasher, you may need to set your water
heater's thermostat up. Ifyou have not used hot wa(er
for some time, the water in the pipes will be cold. Turn
on the hot water faucet at the sink and allow it to run
until the water is hot. Then start the dishwasher, If
you' ve recently done laundry or run hot water for
showers, give your water heater time to recover before
operating the dishwasher.
and you cannot adjust your water heater: Select a
longer cycle and fill both detergent cups at least hali-
full with detergent.
Your dishwasher's rinse agent container holds
approximatel
y
3 months. Fill as needed.
If you accidentall spill: Wipe up the rinse
y
agent with a damp cloth. Don't leave the spill in the
dishwasher. It can keep your detergent from working,
If you can't find any rinse agent, write:
UMER
("JET-DRY" )
Corporate Centre ]
5S Federal Road
Danbury, CT 068 13-i991
PRODUCTS, INC.