Advertisement
Quick Links
MPC-X100 100 Hz Subwoofer Crossover
For JBL MPC and MPA amplifiers
Owner's Manual and Installation Guide
I. Description
*TD-000084-00*
TD-000084-00
Rev. A
100 Hz
Linkwitz-Riley
Low-Pass Filter
Channel 1
(subwoofer)
Programmable
Linkwitz-Riley
Low-Pass Filter
(factory preset @ 20 kHz)
Channel 2
(high-pass or full-range)
Figure 1. Block diagram of the MPC-X100
Programmable
Linkwitz-Riley
High-Pass Filter
(factory preset @ 20 Hz)
jumper block: 3-pin
jumper block: 3-pin
resistor network RN104
header J101
header J101
jumper block: 3-pin
jumper block: 3-pin
header J201
header J203
resistor network RN202
& switch S201
Subwoofer
Output
jumper block: 3-pin
header J102
High-pass or
100 Hz
Linkwitz-Riley
Full-range
High-Pass Filter
Output
jumper block: 3-pin
header J202
Advertisement
Related Manuals for JBL MPC-X100 100 Hz
Summary of Contents for JBL MPC-X100 100 Hz
- Page 1 MPC-X100 100 Hz Subwoofer Crossover For JBL MPC and MPA amplifiers Owner’s Manual and Installation Guide I. Description *TD-000084-00* TD-000084-00 Rev. A 100 Hz Linkwitz-Riley Low-Pass Filter Channel 1 jumper block: 3-pin jumper block: 3-pin (subwoofer) header J101 header J101...
-
Page 2: Installation
II. Installation Input panel LOW IMPEDANCE AUDIO TRANSFORMER DIR. OUTPUT 70 100 ISOL.OUTPUT BRIDGE 100V MONO CH2 INPUT CH1 LOW IMPEDANCE AUDIO TRANSFORMER DIR. OUTPUT 70 100 ISOL.OUTPUT GROUND STEREO LEVEL INPUT PARALLEL BRIDGE LEVEL BRIDGE 100V MONO Figure 2a. The input panel’s location on the rear panel of the amp Wire jumpers: W303/304 and W403/404 (MPC);... - Page 3 NOISE SHIELD NOISE SHIELD #4-40 NUT CH. 1 GAIN CONTROL INPUT PANEL PCB Figure 3 Figure 4 III. Programming the MPC-X100 Figure 3. The MPC-X100’s switches, jumpers, and resistor networks.
- Page 4 Figure 4 × " " 1 Subsonic (high-pass) filter frequency table × " " 1 × " " 0 • • • • • Ultrasonic (low-pass) filter frequency table...
-
Page 5: Typical Configurations
All operation Bypass subsonic (subwoofer) Enable subsonic All operation Bypass ultrasonic Enable ultrasonic Bypass 100 Hz high-pass Enable 100 Hz high-pass , t s , t s Bridged mono IV. Typical configurations & & J203 J201, J202 J203... - Page 6 Full-range speaker system 100 Hz MPC-X100 Subwoofer...
- Page 7 V. Warranty & Contacting JBL www.jblpro.com...
- Page 8 Appendix Identifying resistor networks Use only these three digits to determine resistance code. Disregard the other numerals and letters. JBL Professional 8500 Balboa Boulevard, P.O. Box 2200 Northridge, California 91329 U.S.A. A Harman International Company RESISTANCE CODE 2.7K 3.9K 4.7K 5.6K...