Hardware Installation - Leadtek GPS 9531 Technical Specification

.
FOR PC

Hardware Installation

Note: The system may not function properly if you connect the GPS 9531 to
your computer before the driver is installed.
Step 1.
USB Version
Connect the RJ11
connector of the
GPS 9531 to the
USB cable as shown
in the figure to the right.
Step 2.
USB Version
As in the figure below, connect the
USB connector to a USB port on
your computer.
Step 3.
Computers with USB connectors all have the
USB driver built-in on the system. The system
will automatically search for the driver and
install it when you power on your computer.
Step 4.
The installation is completed.
Hardware Installation
RS232 Version
Connect the RJ11
connector of the
GPS 9531 to the
Y-shaped cable
(RS232-PS2) as shown in
the figure to the right.
RS232 Version
Connect the RS232 connector to a
COM port on your computer, and
PS2 connector, a PS2 port.
7 GPS 9531
- - 23