Advertisement
3.2 Adjusting the Speaker volume
The are 8 volume levels. The current speaker volume level
is displayed on the LCD screen.
To adjust the speaker volume level, press the ▲(UP) button
to increase, or press the ▼(Down) button to decrease. The
LCD screen will display the speaker volume icon bars
according to the settings.
3.3 Receiving a Call
The unit is continuously in Received mode when the unit is
turned ON and not transmitting. When a signal is received
on the current channel, the received signal icon "RX" will be
displayed on the LCD screen, and the receiver LED
indicator will turn on.
3.4 Transmitting a Call
a. Press and hold the PTT (Push-to-Talk) button to transmit
your voice. The transmit signal icon "TX" will display on the
LCD screen.
b. Hold the unit in vertical position with the MIC
(Microphone) 5 cm away from the mouth. While holding the
PTT button, speak into the microphone in a normal tone
voice.
c. Release the PTT button when you have finished
transmitting.
Important:
● In order to receive communication to other people, they must
also be on the same channel that you are currently using. Refer
to the 'Changing Channel' section for more information.
● When the PTT and/or Call buttons are continuously pressed,
your PMR can not receive any transmission.
3.5 Roger Beep
The Roger Beep is a tone which automatically transmitted
whenever the PTT button is released. This tone alert is
receive the other party when you have ended the
transmission, and you are now in receive mode.
3.6 Changing Channels
The PMR has 8 available channels, To change channel, in
normal mode;
a. Press the Menu button once, the Channel icon "1" on the
LCD screen will start blinking.
b. While the channel is blinking, press the ▲(UP) button or
▼(Down) button to select the desired channel. The channel
changes from 1 to 8 or from 8 to 1.
c. Press the Menu button to confirm the selection and return
to normal mode.
3.6.1 HI/Low Power
Selecting the Hi/Low Power
a. Press the Menu button twice.
b. Press the ▲(UP) button to select the high power "Hi"
appears on the display.
c. Press the ▼(Down) button to select the low power "Lo"
appears on the LCD.
d. Press PTT button to confirm your selection.
Advertisement
