Power Button And Led Indicator - Western Digital TV Live HUB User Manual

Power Button and LED Indicator

1
Item Component
1 Power button
2 Power LED
(WD logo)
3 Infrared
receiver
2
Description
• When power LED is on:
-
Press the power button to power down the media center.
The internal drive is put in sleep mode and other devices
can still access it.
-
Press and hold for five seconds to completely shut down
the device and make the internal drive inaccessible.
• When power LED is off—Press the power button to power on
the media center and wake the internal drive.
• On—The power cable is connected and the power is on.
• Off—The media center is in standby mode , turned off, or the
power cable is disconnected.
• Steady flashing— A USB device has been discovered and the
unit is being mounted in the system. If the Media Library is set
to On in the Setup options (see "Media Library Compilation" on
page 29), the LED flashes at the same steady constant rate.
• Three short flashes followed by three long flashed followed by
three short flashes—A system diagnostic failure has occurred.
See "Troubleshooting" on page 210.
• Receives signals from the remote control. Point the tip of the
remote control to the infrared receiver and ensure that the path
between the two is unobstructed.
WD TV Live Hub Media Center
3
FEATURES AND FUNCTIONS – 8
User Manual