Maintenance - DeWalt DC927-XE Instruction Manual

adjustment collar (D) to the desired setting. Make a few practice runs in scrap or
unseen areas to determine the proper position of the clutch collar.

MAINTENANCE

WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories.
Cleaning
WARNING: Blow dirt and dust out of all air vents with dry air at least once a week.
Wear proper ANSI Z87.1 (CAN/CSA Z94.3) eye protection and proper NIOSH/OSHA/
MSHA respiratory protection when performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning the non-
metallic parts of the tool. These chemicals may weaken the plastic materials used in
these parts. Use a cloth dampened only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC outlet before
cleaning. Dirt and grease may be removed from the exterior of the charger using a
cloth or soft non-metallic brush. Do not use water or any cleaning solutions.
Repairs
This charger is not user serviceable. There are no user serviceable parts inside the
charger.
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should be performed by certified
service centers or other qualified service organizations, always using identical
replacement parts.
ACCESSORIES
WARNING: Since accessories, other than those offered by D
tested with this product, use of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D WALT, recommended accessories should be used
E
with this product.
Recommended accessories for use with your tool are available at extra cost from
your local service center. If you need any assistance in locating any accessory,
please contact D
Australia or call 1800 654 155 or (NZ) 09 259 1111.
BITS, METALDRILLING
WOOD, FLATBORING
BITS, MASONRYDRILLING
Guarantee
Applicable to hand held Power Tools, Lasers and Nailers.
Three Year Limited Warranty
D WALT will repair, without charge, any defects due to faulty materials or
E
workmanship for three years from the date of purchase. Please return the complete
unit, transportation prepaid, to any D
service station.
For warranty repair information, call (AUS) 1800 654 155 or (NZ) 09 259 1111.
This warranty does not apply to
• Accessories
• Damage caused where repairs have been made or attempted by others.
• Damage due to misuse, neglect, wear and tear, alteration or modification.
This warranty gives you specific legal rights and you may have other rights under the
provisions of the Consumer Guarantee Act 1993 (New Zealand only), Trade Practices
Act 1974 and State Legislation (Australia only).
In addition to the warranty, D
WALT, have not been
E
D WALT will also maintain the tool for free at any time during the first year of
E
purchase. This includes labour, parts and lubrication required to restore the product to
sound mechanical and/or electrical condition. Normal wear parts are not covered in
this service. Carbon brushes worn more then 50% will be replaced.
11
WALT Industrial Tool Co., 20 Fletcher Road, Mooroolbark, VIC 3138
E
MAXIMUM RECOMMENDED CAPACITIES
Speed 1 Speed 2
12,7 mm (1/2") 6.4 mm (1/4")
38.1 mm (1-1/2") 15.9 mm (5/8")
– 6.4 mm (1/4")
WALT Service Centre, or any authorised
E
WALT tools are covered by our:
E
FREE ONE YEAR SERVICE CONTRACT
Speed 3
6.4 mm (1/4")
15.9 mm (5/8")
6.4 mm (1/4")