Replacing The Fuse Or Neon Tubes - JBL A6000GTi Owner's Manual

SETTING UP THE GTi AMPLIFIER
REPLACING THE FUSE Figure 14. Removing bottom screws
OR NEON TUBES and the clear cover from the A6000GTi
amplifier. NOTE: Do not remove the
The JBL A6000/A3000GTi amplifier
logo badge assembly.
is equipped with an internal fuse, a
20-inch neon tube and two 6-inch neon
tubes. Should the fuse or a neon tube
fail, perform the following steps
to replace the part:
NOTE: For neon tube replacement, see
your authorized JBL car audio dealer
to purchase new StreetGlow ® neon
tubes in 6- or 20-inch sizes.
NOTE: Although the following
steps discuss and illustrate how
to disassemble a JBL A6000GTi,
the disassembly procedure for a
JBL A3000GTi is similar.
1. Disconnect and unmount the
4. Using a T-15 screwdriver, remove
amplifier from the vehicle. On a
soft surface, turn the amplifier over
to view the bottom. Using a T-25
screwdriver, remove the four large
5. Repeat Step 4 for the input panel
Torx-head screws along the bottom
edges and set them aside (see
6. Remove the cover and set it aside
Figure 14).
2. Turn the amplifier over to view the
top. Using a 5 ⁄32-inch Allen wrench,
Figure 15. Removing the input and
remove the four cap screws on the
output screws and the cover from the
clear cover and set them aside (see
A6000GTi amplifier.
Figure 14).
3. Slide the clear cover off and set it
aside (see Figure 14).
the four Torx-head screws around
the output panel and set them aside
(see Figure 15).
(see Figure 15).
(see Figure 15).
9