Table of Contents
Advertisement
Compliance Information
United States FCC Compliance
This equipment has been tested and found to
comply with the applicable limits of Part 15 of
the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio or TV reception,
which can be determined by turning the
equipment off and on. The user is encouraged to
try to correct the interference by one or more of
the following measures:
•
Increase the separation between the
equipment and receiver
•
Connect the equipment into an outlet on
a circuit diff erent from that to which the
receiver is connected
•
Consult your cable company or an
experienced radio/TV technician for help
Any changes or modifi cations not expressly
approved by Cisco Systems, Inc., could void the
user's authority to operate the equipment.
Important: The information shown in the FCC
Declaration of Conformity paragraph below is a
requirement of the FCC and is intended to supply
you with information regarding the FCC approval
of this device. The phone numbers listed are for
FCC-related questions only and not intended
for questions regarding the connection or
operation for this device. Please contact your
cable service provider for any questions you may
have regarding the operation or installation of this
device.
FCC Declaration of Conformity
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1) this device may not cause harmful
interference, and 2) this device must accept any
interference received, including interference that
may cause undesired operation.
Explorer
Digital Home Communications Terminal
Manufactured by: Cisco Systems, Inc.;
5030 Sugarloaf Parkway;
Lawrenceville, Georgia 30044; USA
Telephone 678 277-1120
18
®
8240
Model 8240
Canada EMI Regulation
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la class B est
conforme à la norme NMB-003 du Canada.
Software and Firmware Use
The software described in this document is
protected by copyright law and furnished to you
under a license agreement. You may only use or
copy this software in accordance with the terms
of your license agreement.
The fi rmware in this equipment is protected by
copyright law. You may only use the fi rmware
in the equipment in which it is provided. Any
reproduction or distribution of this fi rmware, or
any portion of it, without our express written
consent is prohibited.
Disclaimer
Cisco Systems, Inc. assumes no responsibility for
errors or omissions that may appear in this guide.
Cisco reserves the right to change this guide at
any time without notice.
20081121 FCC Standard
Advertisement
Table of Contents
