Advertisement
4)
= rapid (or even highspeed).
System Performance
Clicks or dropouts in recording
1)
Start the
ASIO-USB Control Panel from within the audio soft-
ware (may be called ASIO Config or similar).
2)
USB Device
= BEHRINGER USB AUDIO.
3)
Click on the
ASIO tab.
4)
System Performance
= normal.
Visit
www.musicXP.net
for some helpful advice about optimizing
Windows XP for music applications.
3.
Installation for Mac
3.1
Installing the iAXE
To setup the iAXE, proceed as follows:
1)
Power on your computer.
2)
Connect the iAXE with the USB cable to your Mac.
3.2
Installing the Guitar Combos software
The Guitar Combos software consists of three different combos.
Choose any or all of them for installation. With the serial number on
the CD sleeve you can fully activate one combo. The other combos
can be run in demo mode with the following restrictions:
Saving of sounds is disabled
=
Quits after 30 minutes
=
Total recall is disabled
=
To install a combo on your system, proceed as follows:
1)
From the folder "NI Guitar Combos" on your CD, choose the
combo you wish to install and open the respective archive file
(ZIP) by double-clicking on its entry.
2)
Double-click on the installer icon on the desktop, to start the
installation.
3)
Follow the on-screen instructions.
If you have the serial number for the installed combo:
4)
Accept to start the
NI Service Center, upon request.
If your computer is not connected to the internet, choose
+
the offline registration method to activate the combo via
another computer.
5)
Follow the on-screen instructions.
Fig. 3.1:
Product activation with NI's Service Center
If you do not have the serial number for the installed
+
combo, you can only run the combo in demo mode.
To setup the combo, proceed as follows:
1)
Start the stand-alone application of a combo.
2)
In the
Audio Setup window, make your choice according to
the screenshot.
3)
Please note, when using the Guitar Combos plug-in inside
a host application (for example, audio recording software
such as energyXT2), all the signal routing is determined in
the host application.
As of OS 10.X the stand-alone version of Guitar Combos
+
needs an "Aggregate Device" for accessing inputs and
outputs of the hardware. For more information on how to
set up an Aggregate Device, visit www.behringer.com.
Fig. 3.2:
4)
With the
16 ms.
Audacity is a free software for recording and editing sounds.
To install the software, proceed as follows:
1)
Double-click on "audacity.exe" in the "Audacity" folder.
2)
Follow the on-screen instructions.
3)
Start the application and go to
4)
In the
Audio I/O tab, set the Playback and Recording devices
to USB Audio Codec.
5)
Restart the application.
Installation for Mac
iAXE USB-GUITAR
Audio Setup settings on OS 10.4 and above
Output Latency slider, choose a setting below
3.3
Installing Audacity
File > Preferences.
Fig. 3.3:
Audio Setup settings
5
Advertisement
