Table of Contents
Advertisement
3.3 Selecting a site for the Ethernet Extender
As with any electric device, you should place the equipment where it will not be
subjected to extreme temperatures, humidity, or electromagnetic interference.
Specifically, the site you select should meet the following requirements:
-
The ambient temperature should be between -10 to 60 degrees Celsius.
-
The relative humidity should be less than 95 percent, non-condensing.
-
Surrounding electrical devices should not exceed the electromagnetic field (RFC)
standards.
-
Make sure that the equipment receives adequate ventilation. Do not block the
ventilation holes on each side of the equipment.
-
The power outlet should be within 1.8 meters of the product.
3.4 Installation
This chapter gives step-by-step instructions about how to install the Ethernet Extender:
The Microtype works with the provided external power supply (12VDC) powered by local 110/220V
power.
a)
Mount the clip (Fig. 3.2) onto a fixture, e.g. a plank, (either on the wall or on a flat surface)
with two screws through the holes on the mounting frame to secure it in position.
b)
The provided power supply should also be mounted on the same fixture or in the proximity
for connection of the supply cables to the unit, provided that an AC power supply socket is nearby
for powering the adaptor.
c)
Push the Micro unit into the clip to secure it in position. For details, please follow Fig. 3.3.
www.ot-systems.com
(a) Front view
Fig. 3.2 Micro unit's clip
ET1100C Series Installation & Operation Manual
(b) Side view
6
Advertisement
Table of Contents
