The Jacuzzi Chromatherapy Lamp provides beautiful and
practical illumination to your bath. It includes vivid rotating colors
or penetrating white lighting to enhance your Jacuzzi experience,
and is built to give years of service and pleasure.
The Lamp can be installed on most Jacuzzi baths or on any
bath having sufficient flat space on the bath shell. The basic kit
consists of an electrical control box and one Chromatherapy
Lamp, with all necessary modular cables. The control box can
support up to four lamps. An additional lamp kit is available and
provides one lamp and one cable.
The installation requires drilling a hole in the bath shell for the
control panel and each lamp. The Installation and Operation
Instructions will provide all the information required for planning
the installation, completing the installation, and complete
operation of the equipment. The control box must be installed
meeting applicable local building and electrical codes on a stud
beam or wall.
Contents
. . . . . . . . . . . . . . . . . . . . . . . . 5
BasiC Lamp Kits
GD56000 Complete kit
One control box for wall mounting
One control panel and one control cable (RJ-45 plug)
One lamp and one lamp cable (RJ-11 plug)
GQ88000 Accessory lamp kit
One lamp and one lamp cable (RJ-11 plug)
To add an additional lamp, up to four total, order the accessory
lamp kit. It includes one lamp and one lamp cable. Each lamp
is mounted in the same manner, and is connected to the control
box as described. To order additional lamps, please contact your
Jacuzzi dealer or agent.
important: Read the instructions before beginning the
installation.
Copyright © 2008 by Jacuzzi Whirlpool Bath Products
instaLLation and operation instruCtions
. . . . . . . . . . . . . . . . 2
. . . . . . . . . . . 4
. . . . . . . . . . . . . . 5
Chromatherapy Light Kit
pLanning instaLLation
It is necessary to plan the location of the control box, control
panel, and each lamp before drilling any holes. A possible
configuration of the Chromatherapy equipment is shown in
Figure 1.
First, consider the location requirements for the control panel and
lamp(s), see Figure 2. The control panel cannot be immersed
in the bath water. Therefore it must be positioned at least one
inch above the level of the overflow drain. On the other hand,
the lamp(s) must be positioned a minimum of 4 inches below the
normal water line.
Control panel
Lamp 1
Lamp 2
Figure 1. Possible configuation for Chromatherapy assembly
Top rim of bath
Normal water line
Floor of bath
Figure 2. Locate the Holes for Control Panel and Lens(es)
Hole for control panel
1 inch
Overflow drain
4 inches (minimum)
Hole for lamp(s)
GQ99000 • 07-08
Need help?
Do you have a question about the GQ99000 and is the answer not in the manual?
Questions and answers