Final Installation - Panasonic CQ-DP171U Operating Instructions Manual

Installation Guide
E
N
G
L
I
Motor Antenna
S
Connect the car motor antenna lead to the blue motor
H
antenna relay control lead.
17
(Do not confuse the antenna lead with blue/white stripe
lead for a power amplifier.)
Battery
Connect the yellow battery lead to the correct radio wire or
to the battery fuse port on the fuse block.
Antenna
Connect the antenna by plugging the antenna lead into the
antenna receptacle.
Equipment
Connect any optional equipment such as an amplifier,
according to the instructions furnished with the equip-
ment. Leave about 12" (30 cm) of distance between the
speaker leads/amplifier unit and the antenna/antenna
extension cord. Read the operating and installation
instructions of any equipment you will connect to this unit.
Power
Connect the red power lead to the correct car radio wire or
to the appropriate fuse port on the fuse block.
If the stereo unit functions properly with all these connec-
tions made, disconnect the wires and proceed to the final
installation.
❏ Final Installation
Lead Connections
Connect all wires, making sure that each connection is
insulated and secure. Bundle all loose wires and fasten
them with tape so they will not fall down later. Now insert
the stereo unit into the mounting collar.
Congratulations! After making a few final checks, you're
ready to enjoy your new auto stereo system.
❏ Final Checks
1. Make sure that all wires are properly connected and
insulated.
2. Make sure that the stereo unit is securely held in the
mounting collar.
3. Turn on the ignition to check the unit for proper opera-
tion.
If you have difficulties, consult your nearest authorized
professional installer for assistance.
26
CQ-DP171U
(continued)
❏ Preparation
¡We strongly recommend that you wear gloves for
installation work to protect yourself from injuries.
¡When bending the mounting tabs of the mounting
collar with a screwdriver, be careful not to injure your
hands and fingers.
¡Disconnect the cable from the negative
minal (see caution below).
¡Unit should be installed in a horizontal position with the
front end up at a convenient angle, but not more than
30°.
Caution: Do not disconnect the battery terminals of a
car with trip or navigational computer since all user set-
tings stored in memory will be lost. Instead take extra
care with installing the unit to prevent shorts.
Dashboard Installation
Installation Opening
This unit can be installed in any dashboard having an
opening as shown above. The dashboard should be
7
(4.75 mm) – /
32
support the unit.
2 3 / "
32
(53 mm)
7 5 / "
32
(182 mm)
" (5.56 mm) thick in order to be able to
battery ter-
Less than 30°
3 / "
16