Microphone; Key - Trio TS-530SP Instruction Manual

Headphones
Use headphones of 4 to 16O imPe-
dance. The optional HS-4, 5, 6 or 7
headphones best suited for use with
th€ TS-53O Stereo-type phones can
also be used.
Antenna
Surge
arrestor
AL-2
Can be used for
TX monitor
Gl{D terminal
It is recommend€d that a ground lead
b€ conn€cted to the GND terminal at
the rear of the set to prevent the pos-
sibility of electric shock, TVI and BCl.
Use as short and heavy a lead as Pos-
sible.
Microphone
Either a low or high impedance mi-
crophone (5OOO to 50 kO can be
used. The P.T.T. switch should be
isolated from th6 mic circuit (shown
in
"A").
Use a microphone with a se-
oarate switch and MIC line so both
P.T.T. and VOX are available.
, - <
n t--all E
r -
o
trq
' ^ - l l
M'c'ooho.c l) P
9[
, - - l l
|
^ - t t 6 - <
M,c,oeho.. u e____9ll E
| -
I I ' a n s t o ' m c '
O .
- - '
Linear amPlifier
MC-50
MC-60
External speaker
B€sides the built-in speaker,
an external sDeaker can also
be used.
Connect to the rear EXT
SP jack using the supplied
p t u 9 .
sP-230
VFO-23O or
vFo-2tto
\
t-::
Key
For CW operation, connect Your keY
to the KEY tack at the rear. Use
shielded cable.
AC line source
See page 5, AC POWER
6
EI
Fig. 2-1 TS-530 Connections
Extemal VFO