Fuse Replacement; Specifications - SKYTRONIC 173.021 Instruction Manual

Channel 2 control
Channel 2 (12) is the overdrive/distortion channel. This means the channel sets a slight gain which will cause
the output sound to distort. You can set the gain level, low tones (bass), timbre level (contour) and the high
tones (treble) until the output signal suits your needs. These controls can al be set within a value of 0~10.
You can also set the channel volume with the channel volume control.
Master control
The master control controls the overall output signal and also the line out signal. You can set the reverb
(echo/ambience) within a value of 0~10. The volume knob controls the master output volume. Headphones
can also be connected to listen to the master output signal and check if it suits your needs.
Connecting an external effect processor
Wit the send output (4) and the return input (5) it's possible to connect an external effects processor.
Connect a cable with the send output (4) and the input of the effect. Now connect a cable with the effect
output and the return input (5). Now use the effects processor to create an effect you like. This effect will
return to the amplifier pre-amp.
Connecting your amplifier to an external amplifier
Use the line output (3) to connect an external amplifier when you need more output watts. With this function
you're certain that you can still enjoy the great functions of this SkyTronic guitar amplifier only with a higher
output power.

Fuse replacement

ALWAYS disconnect this unit from the mains power supply before attempting to replace the fuse. Remove
the old fuse from the holder and replace with a fuse with the exact same power rating. Replacement with
anything other than the exact same fuse might cause damage to this unit.

Specifications

Power supply: ...................................................................................................... 230 VAC / 50 Hz
Output power: ........................................................ 60 W RMS (173.021) / 100 W RMS (173.024)
Speaker size: ....................................................................................10" (173.021) / 12" (173.024)
Dimensions (hxwxd): ................ 460 x 280 x 480 mm (173.021) / 510 x 300 x 540 mm (173.024)
Weight: ...................................................................................... 12 kg (173.021) / 17 kg (173.024)
•
Specifications and design are subject to change without prior notice.
Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to the unit. This would
also invalid your warranty. The warranty is not applicable in case of accidents or damages caused by inappropriate use or
disrespect of the warnings contained in this manual. SkyTronic UK cannot be held responsible for personal injuries caused by a
disrespect of the safety recommendations and warnings. This is also applicable to all damages in whatever form.