Summary of Contents for Onix CEW182
- Page 1 Wireless Floating Pool Speaker Model Number: CEW182 INSTRUCTION MANUAL After Sales Support: 1300 886 649 (AU) 0800 836 761 (NZ)
-
Page 2: Table Of Contents
Contents Important Safety Instructions Parts and Features Battery Installation Operating Instructions FAQs After sales support: 1300 886 649 (AU) | 0800 836 761 (NZ) -
Page 3: Important Safety Instructions
Important Safety Instructions Read this manual thoroughly before first use, even if you are familiar with this type of product. Keep the manual in a safe place for future reference, along with the completed warranty card, purchase receipt and carton. If applicable, pass these instructions on to the next owner of the appliance. -
Page 4: Parts And Features
Parts and Features Features • Waterproof (complies with international waterproofing standard level IPX7) • Open air transmission range of 30 metres • LED illuminations for mood lighting • Transmission frequency: 40.68MHz • Single channel • Output rating: 3W RMS x 1 (Class AB - audio amplifier) •... - Page 5 Parts and Features (Cont.) Wireless Transmitter Parts List Power ON/OFF (lift the antenna to power on the device, fold the antenna back down to turn it off ) Power LED indicator Audio input cable Audio input DC Power input (6V, 100mA) (Power adaptor is not included) After sales support: 1300 886 649 (AU) | 0800 836 761 (NZ)
-
Page 6: Battery Installation
Battery Installation Pool Speaker Unscrew the LED dome, as illustrated above, left. Remove the screws to the battery compartment, as illustrated above, middle. Insert 4 x C size batteries (not included), matching the polarity markings inside the compartment, as illustrated above, right. Reverse the above procedure to close the unit. -
Page 7: Operating Instructions
Operating Instructions Connect your Music Volume Volume Music Videos Photos Podcasts Extras Settings MENU • Connect the • Activate the transmitter • Switch on the power transmitter to your by flipping the antenna on the pool speaker, music source with the into the upright position, the power indicator will cable provided. -
Page 8: Faqs
FAQs The Power LED does • Ensure the batteries are installed correctly. not light up. • Replace the batteries, if necessary. No sound. • Switch both the pool speaker and transmitter off, then turn them on again to reset both units. •...