If you would like to change the currently configured target:
1. Click on the
single drop-down list.
2. Select your preferred target from the drop-down list. If you prefer not to have
a target, then select the "None" entry (see the note below for details about
why you might do this).
3. Click on
OK
now show a check mark in its
tab.
Connecting Applications to the Device Service
The main purpose of the Device Service is to act as a conduit through which
applications running on your PC can communicate with your headset and interact
with its advanced features (and vice-versa). Use the
Device Service settings window to see a list of applications that are currently
connected to the service
To view a list of connected applications, make sure that the Jabra Device Service
is running and open its settings window from the Notification Area icon. Then
click on the
Applications
Figure 5: The Applications tab of the Jabra Device Service settings window
The
Applications
applications using the following columns:
: the name of a given connected application
•
Name
: the software version number reported by the application
•
Version
: the type of application (e.g., "Softphone")
•
Type
: shows the name of the physical Jabra device to which the
•
Open Devices
Device Service has an open connection for each listed application.
Jabra PC Suite User's Guide
Connecting Applications to the Device Service
button. This opens a simple dialog window with a
Configure
to close the configuration window. Your new selection should
Configured
tab.
tab provides a table that lists information about the connected
Chapter 4: The Jabra Device Service
column on the
Default Softphone
tab of the Jabra
Applications
16