Ingersoll-Rand VR910M Installation Instructions

VR910M/VR914M VANDAL RESISTANT TRIM
1 PREPARE PUSH SIDE OF DOOR FOR EXIT
DEVICE. SEE EXIT DEVICE INSTRUCTIONS
FOR PREPARATION.
2
PREPARE PULL SIDE OF DOOR FOR TRIM.
A TRANSFER VERTICAL AND HORIZONTAL
DEVICE CENTER LINES FROM PUSH SIDE
OF DOOR TO PULL SIDE.
B LOCATE AND PREPARE ALL HOLES AS
INDICATED BELOW.
OUTSIDE FACE
OF LOCK STILE
1-3/8"
11/16"
3-1/2"
2-1/4"
7"
3-1/2"
829560_00(2) Copyright © 2003 Ingersoll-Rand. All rights reserved.

INSTALLATION INSTRUCTIONS

FOR USE WITH MORTISE DEVICES
RHR SHOWN
LHR OPPOSITE
1-5/8" DIAMETER
HOLE (TRIM SIDE
OF DOOR) FOR
CYLINDERS ONLY
DEVICE & TRIM
L C
HORIZONTAL
13/32" DIAMETER HOLES,
4 PLACES (TRIM SIDE)
1/4" DIAMETER HOLES,
4 PLACES (OPPOSITE SIDE)
3
INSTALL MORTISE LOCK. SEE MORTISE LOCK
INSTRUCTIONS.
4
INSTALL EXIT DEVICE AND TRIM.
VR910M/VR914M
TRIM
SCREWS (4):
10-24 X 1"
PPHMS SCREWS
(1-3/4" DOORS)
10-24 X 1-1/2"
PPHMS SCREWS
(2-1/4" DOORS)
5
INSTALL CYLINDER, IF USING.
SET SCREW:
REMOVE FROM CYLINDER
SIDE UNTIL CYLINDER IS SCREWED INTO
PLACE, THEN REINSTALL SCREW
RHR
SHOWN
LHR
OPPOSITE
CYLINDER COLLAR
USE WAVE WASHERS
INSIDE CYLINDER
COLLAR AS NEEDED
FOR PROPER FIT
KEYHOLE
POSITION
WHEN INSTALLED