Violectric DAC V800 User Manual page 13

THE DIGITAL OUTPUT
The digital output is located on the rear panel. It is fitted with a Cinch
socket according to IEC 958, unbalanced at 75 ohms output impedance.
The level at this output however complies with AES-3-id (1 Vss).
The data word on this output is the same as on the selected input by
default. But the output data may also be processed nearly free of jitter
by the resampling module in "BEST"-mode.
To change the mode from the digital output press the "MODE" button for
about 2 sec.
Now either the "x1" LED is lit (default) or the "BEST" LED is lit. Pushing
shortly the "MODE" button will change the status.
Store your entries and leave the menu by pushing the "MODE" button
for 2 seconds.
When "x1" mode was selected the digital output word will be the same
as the digital input word with identical same sample-rate, regardless
which resampling mode (OFF, x1, x2, x4) was selected.
When "BEST" was selected there are the following varieties:
Input Sample-
Rate (kHz)
28 - 55 kHz
55 - 110 kHz
110 - 210 kHz
Internal and Output Sample-Rate at selected Resampling:
OFF
follows input 48kHz
follows input 96kHz
follows input 192kHz
13
1x 2x
96kHz
192kHz
x
4x BEST
192kHz 96kHz
x 96kHz
x 96kHz