Connecting The Appliance - Rinnai RHFE-201FA Owner's Operation And Installation Manual

Connecting the Appliance

1. Attach the air inlet hose to the flue manifold
on either inlet position a o r b .
The unused inlet is plugged with the rubber
cap supplied on the manifold.
2. Connect the flue elbow to the manifold while
moving the appliance into position.
3. Fit the pipe stopper over the connection
between the flue elbow and the manifold.
Engage the hook and rotate it until it snaps
against the body of the clamp.
4. Slide the insulation sleeve up to the flue
manifold and slip the securing clip over the
sleeve as shown.
5. Install the bracket on the rear of the top
spacer by tightening 2 screws.
6. Install the wall bracket with two screws.
Install the top spacer by clipping the spacer
into the wall brackets and attaching it to the
heater with 2 screws.
Top spacer
22
Spacer bracket
Wall bracket
Rinnai Corporation RHFE-201FA
a
Flue Manifold
Pipe stopper
Manifold
Elbow
Fit Clip
Sock
Screw
Spacer bracket
Spacer
Screw
b
Hook
Pipe stopper
Slide
Top spacer
Spacer bracket
Wall bracket