Kenwood TK-90 Service Manual page 17

6-3. Control Cable (KCT-22) Connection
1. Insert one connector of the control cable to the trans-
ceiver (with KRK-5) and the other to the display ( y ).
2. Connect the cable to the GND terminal with the screw
( u ) supplied with the control cable.
3. Secure the one connector of the control cable to the KRK-
5 main panel with two screws ( i ) according to the instal-
lation condition of the transceiver.
4. Secure the control cable to the KRK-5 main panel with the
cable fitting (J21-4354-04) and two screws ( o ) supplied
with the KRK-5.
5. Secure the other connector of the control cable to the dis-
play with two screws ( !0 ) in the same way.
6-4. Display Installation
1. Install the display with the angle bracket (J29-0648-03)
( !1 ) and two screws (N08-0526-04) ( !2 ) supplied with
the KRK-5.
INSTALLATION /
Transceiver
短波通信机
y
i
o
u
Cable fitting
电缆配件
KTC-22
!0
Fig. 6-3 /
!2
!1
Angle bracket
角撑架
Fig. 6-4 /
!=Eh`qJOOF=
SJPK=
!"#$%&'()*+,-./=E
NK
!"#=E y F
!"#$%&'()=E u F=
OK
!"#$%&'()* +,O
PK
!"#$%&hohJR
!"#$= EgONJQPRQJMQF=
QK hohJR
!"#$%hohJR
E o F=
!"#$%&O
RK
!"#$%
KRK-5
GND
main panel / 主控制盘
Display / 显示屏
u
GND
y
SJP
!"#
SJQK=
!"#=EgOVJMSQUJMPF=E !1 F= O
NK hohJR
EkMUJMROSJMQF=E !2 F=
!2
SJQ
TK-90
hohJRF
!"#dka
!"
=E i F=
!"
O
!"
!"#$%&'(
=E !0 F=
!"#
17