Bevel Gear; Sharpening Grass Cutters And Grass Blades - Jonsered GC2128C Operator's Manual

An air filter that has been in use for a long
time cannot be cleaned completely. The
filter must therefore be replaced with a new
one at regular intervals. A damaged air fil-
ter must always be replaced.

Bevel gear

The bevel gear is filled with the right quan-
tity of grease at the factory. However, be-
fore using the machine you should check
that the bevel gear is filled three- -quarters
full with grease. Use JONSERED special
grease.
The grease in the bevel gear does not nor-
mally need to be changed except if repairs
are carried out.
545186857 Rev. 9 5/15/12
MAINTENANCE
Sharpening grass cutters and
grass blades
WARNING:
gine before doing any work on the
cutting attachment. This continues
to rotate even after the throttle has
been released. Ensure that the cut-
ting attachment has stopped com-
pletely and disconnect the HT lead
from the spark plug before you start
to work on it.
S See the cutting attachment packaging for
correct sharpening instructions.
S Sharpen blades and cutters using a
single- -cut flat file.
S Sharpen all edges equally to maintain the
balance of the blade.
WARNING:
or damaged blade could result in
serious injury or death. Always
discard a blade that is bent,
twisted, cracked, broken or
damaged in any other way. Never
attempt to straighten a twisted
blade so that it can be reused.
Only use original blades of the
specified type.
Always stop the en-
Use of an incorrect
English--- 22