Key To Symbols; Symbols On The Machine; Symbols In The Operator's Manual - Jonsered CS 2188 Operator's Manual

Symbols on the mac hine:
W ARNING! Chain saws can be
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator ' s hands must be
used to operate the chain saw.
Never operate a chain saw holding it with
one hand only.
Never let the guide bar tip come in
contact with any object.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar up
and towards the operator. May cause
serious personal injury.
Recommended cutting
equipment in this
example:
- Bar length 16 inches
- Max. nose radius 10
Teeth
- Chain type Oregon 21LP
Other approved bar and chain
combinations in Operator's Manual.
Measured maximum kickback value with
brake for the bar and chain combination
on the label.
Measured maximum kickback value
without triggering the brake, for the bar
and chain combination on the label.
Other symbols/decals on the mac hine refer to special
certification requirements for certain markets.
2 – English
KEY T O SYMBOLS
Symbols in the operator' s
manual:
Switch off the engine b y moving the
stop switch to the STOP position before
carrying out any checks or
maintenance.
Always wear approved protective
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be
worn.
Refuelling.
Filling with oil and adjusting oil flow.
The chain brake should be activated
when starting.
WARNING! Kickback may occur when
the nose or tip of the guide bar
touches an object, and cause a
lightning fast reverse reaction, kicking
the guide bar up and towards the
operator. May cause serious personal
injury.