Fitting Other Guards And Cutting Attachments; Fitting The Trimmer Guard And Trimmer Head - Jonsered GT2125 Operator's Manual

guard as possible. To tighten the nut, turn the spanner in
the opposite direction to the direction of rotation (left-hand
thread).
WARNING! Grass blades or grass knives
!
may only be used when the J-handle is
fitted. Clearing blades must never be used
with the J-handle.
Fitting other guards and cutting
attachments
(GC 2125)
• Fit the correct trimmer guard (A) for use with the trimmer
head. Hook the trimmer guard/combination guard onto
the fitting on the shaft and secure with the bolt (L).
A
• Fit the drive disc (B) on the output shaft.
• Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
H
• To dismantle, follow the instructions in the reverse order.
ASSEMBLY
H
Fitting the trimmer guard and
trimmer head
(GT 2125)
Guard
• Fit the guard as shown in the diagram. Tighten securely.
Trimmer head
• Fit the dust cup on the shaft. The nut must be completely
covered by the dust cup.
• Hold the dust cup with a spanner to prevent the shaft from
rotating.
• Screw the trimmer head onto the shaft.
– 15
English