Attaching Or Removing Bat- Tery Pack; Support Handle - Panasonic EY7442 Operating Instructions Manual

III. ASSEMBLY
Attaching or Removing Bit
NOTE:
When attaching or removing a bit,
disconnect battery pack from tool or
place the switch in the center position
(switch lock).
This tool is equipped with a keyless drill
chuck.
1. Attachment
Insert the bit and turn the lock collar
clockwise (looking from the front) to
tighten firmly until it stops clicking.
2. Removal
Turn the lock collar counterclockwise
(looking from the front), then remove the
bit.
NOTE:
If excessive play occurs in the chuck,
secure the drill in place and
the chuck jaws by turning the lock
collar and tighten the screw (left-
handed screw) with a screwdriver by
turning it counterclockwise (viewed
from the front).
Attaching or Removing Bat-
tery Pack
1. To connect the battery pack:
2. To remove the battery pack:
Lock collar

Support handle

open
- 10 -
Line up the alignment marks and attach
the battery pack.
• Slide the battery pack until it locks in-
to position.
Alignment marks
Pull the button from the front to release
the battery pack.
Button
Place the support handle at your
favorite position and tighten the handle
securely.
Tighten
Loosen
Always use the support handle to
ensure operating safety.