General Owner’s Instructions THANKS! We at Kasco Marine, Inc. would like to both thank and congratulate you on your purchase INSPECT THE SHIPMENT of the Low Voltage Lighting. We appreciate Immediately inspect your Kasco Low Voltage you choosing Kasco and for your purchase.
Light Kit to be free from defects in material or workmanship under normal use 0506 and service. The Kasco Marine, Inc. obliga- tion under this warranty is limited to replacing The fi rst two digits represent the month of or repairing free of charge any defective part manufacture.
Page 4
United States. All other warranty and repair inquiries Other Repairs: should be directed to Kasco Marine, Inc. at 715-262-4488 or Most failed equipment can be repaired at returns@kascomarine.com. substantially lower costs than replacement with new.
Black wires are the HOT wires, Green is the box. Please contact Kasco Marine, Inc. at GROUND wire. Each light fi xture must be submerged at least 1” below the water surface 715-262-4488 for your nearest Authorized for proper cooling during operation.
Adjust the angle of the light fi xture as desired PARTS INCLUDED and tighten the two brass screws on either side of the fi xture to hold that angle. LL1020 Light fi xture with 12 Volt 75W MR-16 Halogen bulb and 20’ cord (1) Brass Screws (2)
LAMPING/RELAMPING Turn off power to light. Unscrew the cap and remove the lens. Install lamp by pushing lamp pins into socket. Seat lamp into fi xture and hold in place with included stainless steel retaining ring. Make sure the O rings are correctly seated and reinstall the lens and cap onto the fi...
All repairs sent in MUST be accompanied by a copy of this completed sheet! • Address your Repair to Kasco Marine, Attn: Repairs (or to your Authorized Repair Center). • Shipping to Kasco or an Authorized Repair Center is paid for by the customer.
Need help?
Do you have a question about the WaterGlow LL1020 and is the answer not in the manual?
Questions and answers