Summary of Contents for Casera PR-803
- Page 1 Hair Grooming Kit Instruction Manual Model number: PR-803 N13275 After sales support AU: 1300 886 649 0800 836 761...
-
Page 2: Important Safety Instructions
Important safety instructions Please keep this instruction manual in a safe place, along with the purchase receipt and carton for future reference. The safety precautions enclosed herein reduce the risk of fire, electric shock and injury when correctly adhered to. •... - Page 3 Know your hair grooming kit parts Bottom blade Blade lever Top blade Power screw On/off switch Accessories Comb cissors Brush...
- Page 4 Operating your electric hair grooming set BEFORE STARTING YOUR HAIR CUT: Ensure the clipper and attachments are free of all debris. Untwist the cord from time to time to avoid tangling Ensure the cutting blade teeth are free from oil. To distribute the remaining oil through the appliance, turn the unit sideward’s.
- Page 5 Attachments COMBS To attach the comb, hold the appliance with its teeth upward and slide it onto and along the clipper blade until the front of the comb firmly sits against the clipper blade. To remove the comb, simply pull the comb upward and away from the clipper blade. Note: For even cutting, allow the comb attachment/cutter to cut its way through the hair.
-
Page 6: Step 2 - Back Of The Head
STEP 2 - BACK OF THE HEAD Change to the next longest comb attachment 7mm or 9mm and cut the back of the head (see diagram 2). STEP 3 - SIDE OF THE HEAD It is recommended that you use one of the shorter combs, either the 3mm or 5mm, to trim sideburns etc. - Page 7 Note: Always work from the back of the head. You can cut the hair shorter gradually by reducing the space between the comb/fingers, and the head. Comb out trimmed hair and check for uneven strands. STEP 5 - THE FINISHING TOUCH Finally, use the taper lever without an attachment comb for close trimming around the base of the neck, the sides of the neck and the ears.
- Page 8 Blade alignment • Your trimmers were carefully examined to ensure that the blades were oiled and aligned before leaving our factory. • Blades must be realigned before if they have been removed for cleaning or replacement. • To realign the blades, simply match the upper and bottom blades teeth up, point to point. (End of top blade teeth should be approximately 1.2mm back from bottom blade.
-
Page 9: Blade Lever
POWER SCREW The power screw permits you to adjust the power. It has been adjusted before leaving the factory. However, if the voltage in your home is low, you may need to re-adjust it. To adjust, use a screwdriver or a thin coin to turn power screw in clockwise direction until the arm strikes the coil, making a noise. - Page 10 Disposal At the end of its working life, do not throw this appliance out with your household rubbish. Observe any local regulations regarding the disposal of electrical consumer goods and dispose of it appropriately for recycling. Contact your local authorities for advice on recycling facilities in your area.
- Page 11 Notes...
Need help?
Do you have a question about the PR-803 and is the answer not in the manual?
Questions and answers