Honda 2007 Civic Hybrid Owner's Manual page 125

Main Menu Main Menu
Playing the Radio (Vehicles with Navigation System)
Voice Control System
In addition to the standard audio
controls, the audio system in your
vehicle can be operated using the
voice control system. See the Navi
section in your Quick Start Guide for
an overview of this system, and the
navigation system manual for
complete details.
To Play the Radio
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
PWR/VOL knob. Adjust the volume
by turning the same knob.
Push the AUDIO button to show the
audio system screen. You can also
operate the audio system without
showing the audio system screen by
using the standard controls. The
status bar is shown at the bottom of
the screen each time you press a
button.
122
Table of Contents
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button, or touch the desired band
icon (FM1, FM2, or AM). On the FM
band, STEREO will be displayed if
the station is broadcasting in stereo.
Stereo reproduction on AM is not
available.
To Select a Station
You can use any of five methods to
find radio stations on the selected
TUNE, SEEK, SCAN,
band:
preset buttons, and
TUNE Use the TUNE bar to tune
the radio to a desired frequency.
Press the bar to tune to a higher
frequency, and the
a lower frequency. When you press
and hold the
beeps twice, and the frequency goes
up or down until you release the bar.
the
AUTO SELECT .
bar to tune to
or bar, the system
SEEK
The SEEK function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press and hold or on the TUNE
bar until you hear a beep, then
release the bar.
The scan function samples
SCAN
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it.
You will see SCAN in the display.
The system will scan for a station
with a strong signal. When it finds
one, it will stop and play that station
for about 10 seconds.
If you do nothing, the system will
scan for the next strong station and
play it for 10 seconds. When it plays
a station that you want to listen to,
press the SCAN button again.