Operation; Setting The Beep; Loading A Cassette Tape; Recording A Phone Conversation - NexxTech 4300473 Owner's Manual

OPERATION

SETTING THE BEEP

You can set the telephone cassette
recorder to beep every 15 seconds
while recording.
Note: You might be legally required to
set to
BEEP TONE
so all parties know the conversation is
being recorded. Check the laws in
your area.
1. Remove the battery compartment
cover and remove the batteries, if
installed.
2. Set
BEEP TONE
phone cassette recorder beeps
every 15 seconds while recording.
3. Replace the batteries and the
cover.
LOADING A CASSETTE
TAPE
Follow these steps to install a cassette
tape (not supplied) in the recorder.
1. Turn the cassette's hub with a
pencil to take up any tape slack.
8
when recording,
ON
to . The tele-
ON
2. Press
STOP/EJECT
cassette compartment door. Put
the cassette in the compartment
with the cassette's open edge fac-
ing you and the full reel on the left.
3. Close the door.
Notes:
• You can buy cassettes of varying
lengths at your local electronic
store.
• Replace the tape at least once a
year, or more often if it is used
heavily.
RECORDING A PHONE
CONVERSATION
You can record both sides of a con-
versation on any phone connected to
the same phone line as the recorder.
1. Set
REC MODE
level, , and
SPEED
desired settings. (See "Setting the
Record Mode" on Page 10, "Set-
ting the Sensitivity Level" on
Page 10, "Setting the Recording
Speed" on Page 11, and "Listen-
ing While You Record", on Page
10.)
to open the
, the sensitivity
to the
MONITOR