Saving And Recalling Memories; Adjusting Display Contrast; Property Of Ramsey Electronics, Inc - Ramsey Electronics SG560 User Manual

BASIC USE

Saving and Recalling Memories:

To save a memory, set up the SG560 into the desired frequency, level, offset and wave shape.
Press SHIFT, STO and the memory location
volatile FLASH memory for recall and will be saved whether or not power is applied to the
unit. Be careful; saving a memory will automatically overwrite whatever was previously in that
memory location without prompting to be sure you want to overwrite!
Example: Save a setup to memory location
To recall a memory, press
saved waveform will be loaded and activated. The current selected memory location is shown
as a character in the upper right of the display.

Property of Ramsey Electronics, Inc.

As a special feature, memory location
This can be set to whatever state is preferred for power up. Setting memory location
0 level, and 0 offset simulates a mute condition, or the SG560 can be set up for the user's
Do not reproduce or distribute.
most common test setup.

Adjusting Display Contrast

Display contrast settings are not saved when the unit is powered down, but can be adjusted
by pressing SHIFT, then the
or
a through f. These settings are stored in non-
b
RCL and then any location from
a is automatically recalled upon startup of the SG560.
MHz and kHz buttons to increase or decrease contrast.
10
a-f and all characteristics of the
a to 0Hz,