03 Planning your trip
Settings
Route proposals
03
Route proposals
At the command
Start guidance
several similar suitable options. Select this if
the driver should be asked in case there are
several options to choose from:
•
Select
1
if the navigation system is to select
the most suitable option.
•
Select
3
if the driver is to be able to select
between the maximum 3 suggestions.
See more information on page 45.
1
Available options vary depending on market/area/state.
50
Customise route
Customise route
there may be
Here you can deselect certain traffic sugges-
tions. Tick to avoid the following element
along the route:
•
Avoid motorways
•
Avoid toll roads
•
Avoid ferries
•
Avoid congestion charging zones
•
Avoid tunnels
•
Avoid time restricted roads
•
Avoid season restricted roads
•
Avoid car trains
•
Avoid unverified roads
•
Avoid borders
NOTE
•
If an itinerary is entered when these
selections are made, there may be a
certain delay after an alternative has
been ticked/unticked because the
travel plan must be recalculated.
•
If tunnels, toll roads and motorways are
deselected these are avoided to the
greatest possible degree and only used
if there are no other suitable alternative
is available.
Route learning
1
Route learning
The basic condition is a stored itinerary. If the
driver deviates from the itinerary and take a
different route to the final destination than the
system recommends, the system memorizes
the driver's choice.
If the same itinerary is used again 2 times and
the driver repeats the route choice, the system
will instead show the path that the driver
selected.
Ticked window means that a route that is
driven 3 times is stored as itinerary instead of
the original itinerary.