Setting The Gain; Setting The Crossover; Final System Check; Gray/Black - Clarion XC1410 Owners & Installation Manual

Option 2
4-Channel Full Range stereo system using head unit with (high level) speaker
input
RCA INPUT
90Hz
60Hz
White FL (+)
White/Black FL (-)
Gray FR (+)
Gray/Black FR (-)
Green RL (+)
Green/Black RL (-)
Purple RR (+)
Purple/Black RR (-)
1 2 3 4
In this application, the XC1410 is used as a 4-channel amplifier to drive four full range speakers
in stereo. This configuration is for headunits with High Level Speaker Outputs. Please note: this
configuration is also for Factory OEM headunits.

SETTING THE GAIN

The Clarion XC1410 features a selectable Input Gain Control (High, Low).
Using the Gain Control Switch, select the desired mode:
LOW = when using RCA inputs
HIGH = when using HIGH LEVEL SPEAKER inputs

SETTING THE CROSSOVER

The Clarion XC1410 features a selectable crossover (60Hz, 90Hz, Flat).
Using the Crossover Mode Switch, select the desired mode:
60Hz High Pass
90Hz High Pass
Flat = Crossover OFF for FULL RANGE

FINAL SYSTEM CHECK

1. Power on the source unit. Slowly increase the Volume Control and listen to
the audio.
2. Check "Source" Balance (Left and Right) and Fader (Front and Rear) to ensure
proper installation.
3. Increase the volume and verify that the amplifier reproduces audio (at full
frequencies) without distortion. If you hear distortion, check the connections and
verify that the Input Gain Control is set properly.
6
XC1410
SPEAKER INPUT
FLAT LOW HIGH
+12V Battery (Red)
Chassis Ground
5 6
PWR/PRT
SPEAKER OUTPUT
POWER INPUT
White
White/Black
Gray

Gray/Black

Green
Green/Black
Purple
Purple/Black
Blue/White