Tips And Safety Instructions - Mitsubishi Electric LDT65IL Operation Manual

TIPS AND SAFETY INSTRUCTIONS

- The TFT color LCD panel used in this monitor is made with
the application of high precision technology. However, there
may be minute points on the screen where pixels never light
or are permanently lit. Also, if the screen is viewed from
an acute angle there may be uneven colors or brightness.
Please note that these are not malfunctions but common
phenomena of LCDs and will not affect the performance of
the monitor.
- Do not display a still picture for a long period, as this could
cause a residual image.
- Never rub or tap the monitor with hard objects.
- Please understand that MITSUBISHI ELECTRIC
CORPORATION bears no responsibility for errors made
during use by the customer or a third party, nor for any other
malfunctions or damage to this product arising during use,
except where indemnity liability is recognized under law.
- This monitor and its accessories may be upgraded without
advance notice.
- Do not use the monitor where there is a lot of dust, where
humidity is high, or where the monitor may come into contact
with oil or steam, as this could lead to fi re.
- Ensure that the monitor does not come into contact with
water or other fl uids. Ensure that no objects such as paper
clips or pins enter the monitor as this could lead to fi re or
electric shock.
- Do not place the monitor on top of unstable objects or in
unsafe places. Do not allow the monitor to receive strong
shocks or to strongly vibrate. Causing the monitor to fall or
topple over may damage it.
- Do not use the monitor near heating equipment or in places
where there is likelihood of high temperature, as this may
lead to generation of excessive heat and outbreak of fi re.
The Power Cord
- Do not damage the power cord nor place heavy objects on
it, stretch it or over bend it. Also, do not add extension cords.
Damage to the cord may result in fi re or electric shock.
- Use only the power cord supplied with the monitor.
- Insert the power plug directly into the AC outlet.
Adding an extension cord may lead to fi re as a result of
overheating.
- Do not remove or insert the power plug with wet hands.
Doing so could result in electric shock.
- Unplug the power cord if it is not used for a long time.
- Do not attempt to repair the power cord if it is broken
or malfunctioning. Refer the servicing to the service
representative.
Initialization
- This monitor can remember e-mail addresses and other data.
Before transferring or disposing of this monitor, initialize all
settings by executing ALL RESET 1. (See Operation guide.)
Executing ALL RESET 2 will not reset e-mail addresses and
similar data.
Fluorescent Tubes
• The fl uorescent tubes in this product have a limited lifetime.
• Because of the property of fl uorescent tubes, the screen
may fl ash during the initial period of use. If this happens,
please turn off the main power switch of the monitor and
turn on again after at least 5 seconds to confi rm operation.
5
E